I just got two, the Compact Graflex discussed in a separate post, and a Jr. Graflex 2X3. My question is how the capping curtain is controlled; I see no separate control for it. Is its operation automatic?

While the curtain in the Jr. is dried and unworkable, the Compact has a good shutter. However, while I can get the primary curtain to move through all of its settings, the capping curtain is closed and never opens. The shutter release does not work, so there is something wrong there that may be the real issue. I'll look at it tomorrow.

I have never heard of a capping shutter in a Graflex SLR.

On the shutter cocking lever there may be a wheel or slide with I and T stamped on them. I is for instanteous, T is for time. Being you said the curtain will wind to all slots it it most likely in the I position. If it is inbetween settings some parts may not work porperly. Set to I. Push cocking lever downward until it locks, shutter is now cocked.

Graflex SLR's and accessory Focal Plane Shutters for large format cameras all work the same. The on line RB manual will give you all you need to know to operate the shutter, only minor control differences between cameras.


Open the camera, remove the lens board, look at the bottom center of the reflex mirror bracket. The linkage from the shutter release connects with the mirror brackett wihch is spring loaded to the up position. DO NOT pry anything. Put a drop or two of light machine oil on any pivoit point and allow to sit for a few minutes. Work the shutter release lever or try to move the linkage at the mirror base with a small screwdriver but put no more than 1/2 ounce pressure on it.

When you get it to go, wind curtain to T and trip shutter, lens baord to film plane should be open with no intrusions of any kind.

Charles

a few early Graflexes have capping shutters; this is accomplished by employing a second curtain whose sole function is to close the gate while the primary curtain is being wound. The mechanism is known to be somewhat unreliable, and was eventually discarded for the classically simple and reliable shutter we are all familiar with.

So the Compact Graflex that is the subject of my recent posts does, in fact, have a capping shutter, and I suspect that the mechanism is causing my problems. I'll play with it tomorrow, and if I am lucky it can be fixed without going in too deep. While the simple shutters are a cinch to work on, these double jobs are another matter entirely.

And I should not have included the Jr Graflex in this post; it has a simple, non-capping shutter, which is, alas, Krispy-kaput.



<font size=-1>[ This Message was edited by: disemjg on 2006-05-05 19:54 ]</font>

did you find a way to repair your capping shutter? I also have a Compact and I have a similar issue.

I have a compact 5x7 (which I assume has a capping shutter).
Never having seen one before, I'm trying to figure out how it works -
I can't get the mirror into viewing position (the cocking lever just won't work)

For all,
I have drawings I can send of the mechinism, most are very difficult to work on, as most compacts I have seen have all the hardware under the leather covering! Anyone interested in the drawings, contact me at
bsaunders1@bak.rr.com
Have a nice day.......Bert