View previous topic :: View next topic |
Author |
Message |
crawdad
Joined: 22 Jun 2001 Posts: 16 Location: Heart of Georgia
|
Posted: Wed Oct 31, 2001 8:08 pm Post subject: |
|
|
I recently got the fiber case for my Crown Graphic 4X5 and was trying to figure out where everything goes. I could just cram it all down in there "somewhere", but would rather know what each compartment is designed for. I thought I had seen a diagram of this somewhere, but can't remember. Does anyone have a sketch or diagram they could post or send to me? Thanks very much.
_________________ Ron |
|
Back to top |
|
|
alecj
Joined: 09 May 2001 Posts: 853 Location: Alabama
|
Posted: Fri Nov 02, 2001 4:20 pm Post subject: |
|
|
I'll give it a go, Ron. Like everything else from Graflex, there were different models. My sticker is glued to the case, but here's what mine says:
Start with the middle, front. Obviously, that's the camera. It has moveable partitions so that it will fit either a Speed or Crown [I've got the Crown like you]. Mine fits in laying on its left side down, rangefinder up. Then go clockwise to the left. Some have a pocket at the end of the camera slot, into which a lens on a lensboard fits. If so, it has a snap cover. Some don't have that. Against the left wall, the 5" reflector. Around the corner, on the back corner wall, the 7" reflector. I also put my extension flash equipment down around in there as well, with the extension cords, the strap for the case [some cases were longer than others, and had straps which went around the case allowing it to be carried over the shoulder - some don't have that] and remote release cord.
Middle back pocket, Graflex says flashbulbs, accessories. I keep flash cords there as well. Both pockets on right wall, holders. Graflex says holders, accessories for the back pocket, and just holders for the front pocket. My combination depends on how many Grafmatic backs I'm carrying. I usually just carry 8 double film holders.
On the inside top, from the left, sunshade, then 3-cell battery case on the bottom, and flashcords under the elastic above [I don't use that arrangement since it would obviously stretch the elastic eventually.
That's what the sticker from Graflex says, with my deviations. Oh, I also modify my case with thin pieces of foam rubber under and behind the camera. I just don't want it rattling around in there. I keep instructions books, etc. in the slot in front of the camera next to the front wall.
[ This Message was edited by: alecj on 2001-11-02 08:24 ] |
|
Back to top |
|
|
crawdad
Joined: 22 Jun 2001 Posts: 16 Location: Heart of Georgia
|
Posted: Fri Nov 02, 2001 5:02 pm Post subject: |
|
|
Thanks very much, appreciate your help. I had guessed right on some of it after all! |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|