Quote:

On 2004-09-01 18:42, t.r.sanford wrote: The hole is straight-sided, 2-15/16 ins. on a side, with rounded corners. I haven't tried it, but I think a shallow cylindrical cup about 2-7/8 ins. in diameter and perhaps an inch or an inch and a half deep, formed of thin sheet metal, could be mounted behind a "Pacemaker" lensboard to carry one of the old, diminutive wide angle lenses (a 75mm. f:9 "W.A. Dagor," for example) in a small shutter. I think it would leave you room to reach in and set the shutter, and to attach an offset cable release extension.

I think that if you could make them, you could certainly sell them! Wouldn't mind a couple myself!

I'm planning on making a recessed board out of brass shim stock. The stuff is pretty thin. But it's for a camera with a bigger lensboard so should be easier.

Right now it's third or fourth on the to do list-( Just need to build two backs,build 75% of the other camera then I can make the board-)

<font size=-1>[ This Message was edited by: Nick on 2004-09-01 21:06 ]</font>