| View previous topic :: View next topic |
| Author |
Message |
stephied
Joined: 14 May 2015
Posts: 1
Location: New York
|
 Posted: Tue May 26, 2015 8:43 pm Post subject: Trying to reattach belows |
 |
|
Does anyone have any suggestions on reattaching the bellows on a Century Graphic?
This is what i'm looking at...
 |
|
| Back to top |
|
 |
shutterfinger
Joined: 09 Mar 2007
Posts: 57
|
| Posted: Wed May 27, 2015 8:06 pm Post subject: |
|
|
Remove the lens board/lens from the front standard.
Remove the focus panel from the camera back.
Loosen the two top and two bottom graflok slider bar retaining screws until there are two threads of each still engaged in the bellows retaining plates.
Slide the front standard-bellows assembly onto the rails.
Press inward in the two lower slider screws and slip the lower rear edge of the bellows under and behind the lower bellows retaining plate.
Press in on the two top slider screws and slip the top bellows edge over and behind the top bellows retaining plate.
Tighten the screws.
Attach focus panel.
Attach lens board and lens. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
